Nov 21, 2021 · If I had to replace all the gears with their aftermarket and plus the bearing/seal kit from Cat it will be around $6500 for materials. Provided the dead axle and hubs are all serviceable. So in today's market say about 3 cows worth.

Apr 4, 2017 · If the machine has too run ASP I would source a complete final assembly, new dead axle, ALL hardware and final drive oil. R&I 6hrs or less. If the machine has a ripper and dozer, jack is built on, you do need a few blocks and small hydraulic jack to lift the diagonal brace back into position @ reassembly.

Feb 9, 2021 · The dead axle is tapered fit into the rear final housing and retained by a nut and lock plate. You can see that underneath the machine where the wishbone attaches. The final isn’t designed to be removed the way you are trying to do it.

Nov 5, 2006 · I have been looking for a dozer for couple of months and have found a D6D. Problem is the final drive on the left side was low and a magnet picked up some cuttings everything okay on the right. Everything else was working at about thelevel I would suspect.

Mar 18, 2018 · All of my tractors had rippers, because of them I never removed a track frame to rebuild a final drive, just disconnected it from the dead axle and jacked up on the rippers to allow room to remove the sprocket, did this to both D6D, D8H and D8K.

The dead axle is tapered fit into the rear final housing and retained by a nut and lock plate. You can see that underneath the machine where the wishbone attaches. The final isn’t designed to be removed the way you are trying to do it.

They have an adapter to fit on the axle and a sleeve to mate to the press. Then 70 tons of pressure is used to pull the axle out of the taper.

Looking for Caterpillar D6D Bulldozer parts? You've come to the right place. We sell a wide range of new aftermarket, used and rebuilt D6D replacement parts to get your machine back up and …

Untrained operators and failure to follow instructions can cause injury or death. This Caterpillar CAT D6D Track-Type Tractor Service Repair Manual (04X00001 and up) contains detailed repair instructions and maintenance procedures to facilitate the …

Mar 30, 2014 · We had to rent a 100 ton porta-press to remove the dead axle from a D6. When it finally budged it sounded like a shotgun going off. No grease gun has that kind of pressure. When we installed the new bearing on the new dead axle we had to put the axle in the deep-freezer to shrink it and boil the bearing in oil to expand it. Then it went on, no ...